General Maintenance; Blade Sharpening; Periodic Maintenance; Air Filter - EDM Koma Pro 08338 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

the work to ensure that the machine is kept in a perfect
condition.

8.1.1. GENERAL MAINTENANCE

Keep clean the machine, especially the fuel tank area and
areas near the air filter.
Maintain your machine clean and in good conditions.
Clean the covers with a humid towel. Never use petrol or
other flammable products to clean the machine.

8.1.2. BLADE SHARPENING

Blade sharpening should be done in an authorized after
sales. Do not sharpen the blade by yourself. The blade
must be sharpened guaranteeing the correct angle and
equilibrium of the blade. Sharpening if not an expert can
cause excessive vibrations that could cause damages to
the machine and will make the use of the machine very
uncomfortable to the end user.
Be careful when checking the state of the blade,
remember that although the engine has stopped the
blades can be moved manually.

8.2. PERIODIC MAINTENANCE

Make periodic inspections of the machine to ensure that
the machine is correct.
For a thorough inspection take the machine to your dealer.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on the
official distributor of the machine. Using other sparks may
causes risks, damage to the user or people around the
machine.
Carry out maintenance work based on the following table:
Each 2 petrol
Operation
deposits

Air filter

Petrol filter
Spark plug
Cylinder fins
To grease the
Gearbox
8.2.1. AIR FILTER
The dirt in air filter will cause a reduction in machine
performance.
Check and clean this element. If you notice damage or
alterations replace it with a new filter.
To clean the filter:
1. Remove the protecting cover.
2. Remove the filter.
3. The dust accumulated on the outside of the filter
can be removed using your hands or against a
hard object.
4. Clean the filter with soapy water.
5. Rinse the filter with abundant water.
6. Allow the filter to dry.
7. Once dry, place two drops of oil (do not put too
much oil as otherwise the machine will not start).
8. Reinstall the air filter.
9. Replace the protecting cover.
Note: The engine should never started without the air filter
being in place.

8.2.2. FUEL FILTER

67/100
Each 10
petrol
Once a year
deposits
English

Publicidad

Tabla de contenido
loading

Productos relacionados para EDM Koma Pro 08338

Tabla de contenido