Important - EDM Koma Pro 08338 Manual De Instrucciones

must pay more attention to visual warnings as you will
hear less because of the ear protectors.
You must always carry:
- Tooling
- Signalling tape to limit work area.
- Mobile phone (for use in case of an
emergency)
2.2.2. VIBRATIONS
The prolonged use of the machine, exposes the client
to vibrations that in extreme cases and through many
hours of use of the machine could cause the ¨white finger
syndrome¨ also known as Raynaud phenomenon. This
causes a reduction in the tact of the fingers and their
capacity to regulate temperature generating a lack of
sensibility. This sickness could in extreme cases cause
problems with the nerve endings.
The exposure to the vibrations is the cause of the white
finger syndrome. To minimise this effect as much as
possible, follow the following recommendations:
- Always use gloves
- Always have your hands warm
- Ensure that the cutting device is always sharp.
- Take frequent breaks
- Always hold the machine tightly by the handles
If you detect any of the symptoms of the white finger
syndrome, consult immediately with your doctor.
2.3. SECURITY IN THE WORKPLACE
Do not work with the machine in areas with an explosive
atmosphere or near inflammable liquids, gases or dust.
Do not start the machine in a closed area. The exhaust
fumes and the vapours of the petrol all contain carbon
monoxide and other dangerous chemical substances. In
case of gas concentration due to insufficient ventilation,
eliminate from the work area everything that impedes the
correct flow of air and do not work in this area again until
it is well ventilated and the gas concentration does not
happen again.
The area included in a 15m radius around the machine
must be considered risk zone and nobody should be there
while the machine is working and, when necessary, a cord
and warning signals must be used around the working
area
Maintain children and passers-by well clear when working
with the machine. Distractions can cause a lack of control.
When work is to be performed simultaneously by two or
more persons, always check for the presence and location
of others so as maintain a distance between each person
sufficient to ensure safety.
2.4. SECURITY WHEN USING FUEL
IMPORTANT: The fuel used is highly
inflammable. If the fuel or the machine catch
fire, fight the flames with a dry dust fire extinguisher.
Always avoid eye contact with the fuel and the oil. If petrol
or oil were to come into contact with your eyes, clean
these immediately with clean water. If your eyes are still
irritated, visit the doctor immediately.
Do not refill the machine in a closed area. The
petrol and oil vapours all contain dangerous
chemical substances. In case of gas
concentration due to insufficient ventilation, eliminate from
the work area everything that impedes the correct flow
of air and do not work in this area again until it is well
ventilated and the gas concentration does not happen
again.
Gasoline and oil are extremely flammable and explosive
53/100
English