EDM Koma Pro 08338 Manual De Instrucciones página 65

If you slip or fall stop accelerating and move the switch to
"O" (Off).
Do not bring any cutting elements near when the
machine is in use and the engine running.
Do not rely solely on the warning signs on the machine.
Be always alert.
It is neccesary to pay attention to posible loosening or
overheating of parts of the machine. If you detect any
anomalies stop inmediatly the machine and check it
carefully. In case of failure take the machine to the repair
service. In any case you should continue working if you
feel that the performance is not correct.
Remember to always use the machine with clean hands
and without petrol and oil.
Clean the work area and eliminate any obstacles that
could cause accidents. Check the working area and
remove any objects that could cause the cutting tool of
the machine to get tangled on. Also remove any parts that
the cutting tool could violently hit causing these to move in
the direction of the user or other people and/or animals.
Do not allow any other person into the work area. All other
people must be at least at a distance of 15 metres as it is
a dangerous area.
Never leave this machine unattended.
It is imperative that the engine is turned off when carrying
the machine from one working area to another.
Never touch elements that can be hot during the start up
or operating the machine, for example, the escape, sparks
or high voltage cables.
Do not use accessories except those recommended by
our company as otherwise the use of other non original
accessories could cause severe damages to the end user,
to passers-by and to the machine.
Always follow the safety rules stated in this manual.
7.1. FIXING THE MACHINE AND GUIDANCE
Hold the machine with the harness, hands on the handles
and with the right hand in such a position that you can
action the controls (accelerator and security switch).
Attention! So as to reduce the risk of loss of control
and possible damages (that could even be fatal) to the end
user and/or those surrounding him, never use
this machine single handedly.
7.1.1. CUT WITH THE NYLON HEAD
WARNING: Wear eye and audible protection at all
times. Do not look directly to the cutting line because can
cause serious damage to the head and the eyes.
Use the head line in difficult areas.
If the header hits a rock or other object stop the machine
and check its status. Do not use damaged or poorly
balanced heads.
Hold the brush cutter in the way that the head do not
touch the ground and with an inclination of 20º in the
sense you are cutting.
Make cuts from the left to the right to prevent that the
grass fall into the cutting area. Be careful to not hit the
head with rocks or the ground. The beatings against
objects or the ground will reduce the life of the head, may
spoil creating a dangerous environment for you and the
people close to you.
The nylon threads are shortened with the use, when they
are too short accelerate the engine and press the head
against the ground. Then leave wire from the head. If you
leave too much wire the blade will cut in excess.
65/100
English