Checking The Clutch; Machine Usage - EDM Koma Pro 08338 Manual De Instrucciones

English
Allow the engine to warm up for approximately one minute
before starting to work with the machine.
6.4.3. STARTING THE MACHINE FROM HOT
1. Move the switch (A) to the "I" position.
2. Move the lever (E) to the
3. Pull the start rope until the machine starts.
If the machine does not start after pulling at the rope a
few times, please refer to the cold start up section.
6.4.4. ENGINE STOPPAGE
1. Let go of the accelerator (C) and let the engine run
at idle speed for a few seconds.
2. Stop the engine by displacing the switch from the
(A) position to the ¨O¨ position (stoppage).
6.4.5. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible
loosening or overheating of parts of the
machine. If you detect any anomalies stop
inmediatly the machine and check it carefully.
In case of failure take the machine to the repair service. In
any case you should continue working if you feel that the
performance is not correct.
Do not use the machine if it is damaged or incorrectly
regulated.

6.4.5.1. CHECKING THE CLUTCH

After starting up and the engine is hot, the cutting tool
must not be moved if the engine is idle. If the cutting tool
turns with the engine running and without accelerating,
it will be necessary to regulate the idling regime of the
engine. To do this, turn the carburetor nut "T" until the
engine stops.
position.
64/100
If you are unable to regulate the idling regime to stop the
cutting tool, because the engine stalls,
please contact the customer service
for help.
The regulation of the screws (H) and
(L) must only be carried out by an
official technical servicer.

7. MACHINE USAGE

Only use this machine for those jobs for which it has
been designed. The use of this machine for other uses is
dangerous and could cause damages to the user and/or
the machine.
Do not start the machine in a closed area. The exhaust
fumes, the vapours of the petrol and oil, all contain carbon
monoxide and other dangerous chemical substances. In
case of gas concentration due to insufficient ventilation,
eliminate from the work area everything that impedes
the correct flow of air and do not work in this area again
until it is well ventilated and the gas
concentration does not happen
again.
Mow only at daylight or in good artificial light. Do not use
this machine at night, with fog and with reduced visibility.
Always make sure that you can clearly see all the working
area.
Avoid operating the equipment in
wet grass, where feasible. Take
special care when using this
machine in the rain or after rain
because the ground is slippery
and you can slip.