Fein Slugger JHM USA 101 X Instrucciones De Uso página 15

Starting and stopping the drill motor
(figure 10).
Starting:
Switch the motor switch ON.
Stopping:
Switch the motor switch OFF.
Shutting magnet OFF:
Switch off the magnet with the magnet
power switch.
Feed (figure 11).
Feed using the spoke handle.
Instructions for core drilling.
Do not stop the drill motor during the drill-
ing procedure.
Only remove the cutting tool from the hole
while the motor is running.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Chips are sharp and hot!
CAUTION
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, use a
Slugger ID sharpened cutter for stack drill-
ing.
ON switch
en
15
OFF switch
Spoke handle