Publicidad
Idiomas disponibles
Idiomas disponibles
Intended use of the power tool:
Magnetic base drill for drilling with annular
cutting tools on ferrous materials in con-
trolled environments using the cutting tools
and accessories recommended by the man-
ufacturer.
Operation of the power tool off power generators.
This power tool is also suitable for use
with AC generators with sufficient
power output that correspond to the Stan-
dard ISO 8528, design type G2. This Stan-
dard is particularly not complied with when
the so-called distortion factor exceeds
10 %. When in doubt, please refer to the
generator instruction/specification guide.
Symbols.
Symbol, character
DANGER
WARNING
CAUTION
Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction
Manual and the General Safety Instructions.
Before commencing this working step, pull the power plug out of the
socket. Otherwise there will be danger of injury if the power tool
should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
This symbol confirms the certification of this product for the USA
and Canada.
This sign warns of a directly imminent, dangerous situation. A false
reaction can cause a severe or fatal injury.
This sign indicates a possible dangerous situation that could cause
severe or fatal injury.
This sign warns of a possible dangerous situation that could cause
injury.
Worn out power tools and other electrotechnical and electrical
products should be sorted separately for environmentally-friendly
recycling.
Product with basic insulation and exposed, conductive parts addition-
ally connected to the ground conductor.
Operating the power tool off
WARNING
power generators whose no-
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
en
7
Publicidad
