Setting The Water Quantity - Kärcher BR 530 Ep Manual De Instrucciones

Open the cover of the fresh water reser-
voir.
Fill in fresh water (maximum 60 °C).
Add detergent. Follow dosing instruc-
tions for detergent.
Recommended detergents:
Application
Regular cleaning
(even for floors sensitive
to alkalies)
Cleaning dirt from
grease
Basic cleaning (strip-
ping) of alkali-resistant
hard coatings
Basic cleaning (strip-
ping) linoleum
Sanitary cleaning
Disinfection cleaning
Detergents are available in specialised
stores.
Close the cover of the dirt water reser-
voir.
Driving
Detergent
RM 745
RM 746
RM 69 ES ASF
RM 69 ASF
RM 752
RM 754
RM 25 ASF
RM 732
EN
Insert the looped end of the extension
cable in the strain relief hook.
Plug in the mains plug.
Press control switch.
Note
If the brush motor does not run when
switched on, then brush motor is to be re-
leased by pulling the machine backward.
Chassis
Down
Up
Raise the device slightly at the handle.
Pull out the lock.
Tilt the chassis to the desired position.
Put the lock.
Driving to the Place of Use
Tilt the chassis downward and lock it.
Push the machine to the place where it
is to be used.
Cleaning
Tilt the chassis upward and lock it.
Perform the cleaning operation.
Set advance speed (only BD 530 or
BD 530 XL)
Reducing the speed: Turn the button in
"–" direction.
Increasing the speed: Turn the button in
"+" direction.

Setting the water quantity

Set the water quantity at the regulation
knob according to the dirt level and the
type of flooring.
4
-
Transport
Cleaning
19