Setting The Vacuum Bar; Lower The Vacuum Bar - Kärcher BR 530 Ep Manual De Instrucciones

Note
Carry out initial cleaning attempts with low
quantity of water. Slowly increase the wa-
ter quantity till the desired cleaning result is
achieved.

Setting the Vacuum Bar

Oblique position
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
Loosen cross-handles.
Turn the vacuum bar.
Tighten the cross-handles.
Inclination
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
Release the wing nuts.
Tilt the vacuum bar.
20
Tighten the wing nuts.

Lower the vacuum bar

Turn the lever downwards; the vacuum
bar is lowered.
Switch on the suction turbine using the
switch.
Switching on the cleaning head
Caution
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Activate the control handle; the brush
motor starts up.
5
-
EN