Cybex Platinum Sirona Z2 i-SIZE Manual De Instrucciones página 9

PRODUCT PARTS
Battery compartment (1)
Base (2)
Load leg (3)
Newborn inlay* (4)
Size indicator (5)
ISOFIX-Release buttons (6)
ISOFIX-Locking arms (7)
ISOFIX-Anchorage points (8)
ISOFIX-Indicator (9)
Load leg adjustment button (10)
Load leg indicator (11)
Seat locking indicator (12)
Linear side-impact protection
(L.S.P.) (13)
L.S.P. Release button (14)
THE CORRECT POSITION IN THE VEHICLE
This is an i-Size Enhanced Child Restraint System. It is approved according to
UN Regulation No. R129/03 on Base Z2 and No. R129/02 on Base Z, for use in
i-Size compatible vehicle seating positions as indicated by vehicle manufacturers
in their vehicle user manuals. If your vehicle does not have an i-Size seating
position, please check the enclosed vehicle Type List. You can obtain the most
up-to-date version of the Type List from www.cybex-online.com.
*Extra equipment
Seat release handle (15)
Load leg parking position (16)
Headrest (17)
Headrest adjustment handle (18)
Position adjustment handle (19)
Seat rotation handle (20)
Driving direction control (D.D.C) (21)
Driving direction indicator (22)
Belt adjustment button (23)
Shoulder belt (24)
Belt buckle (25)
Buckle tongue (26)
Lap belts (27)
Central adjustment belt (28)
User guide compartment (29)
DIFFERENT USES OF THE SEAT
45 – 105 cm,
max. 18 kg
BASE Z2 BASE Z2
BASE Z2
BASE Z2 BASE Z2
BASE Z2
BASE Z2
BASE Z
BASE Z
45 – 60 cm > 60 cm
If you purchased the seat with a newborn inlay* (4), it will already be placed in the
car seat when you take it out of the box. This should be removed if your child is
taller than 60 cm.
The Size indicator (5) shows the size your child must reach before it is permitted
to convert the seat for forward-facing use.
PREPARING TO INSTALL THE BASE Z2
Before using the base for the first time, the plastic strip must be removed from the
Battery compartment (1) on the load leg. The Base (2) will emit an audible warning
signal until it has been correctly installed. If the Load leg (3) is folded out and
there is no sound, the battery must be checked. To check the battery, the Battery
compartment (1) on the back of the load leg can be opened with a screwdriver.
The battery may only be replaced with a CR2032 size battery.
INSTALLATION IN THE VEHICLE
Always ensure that...
• the backrests in the vehicle are locked in their upright position.
• when installing the car seat on the front passenger seat, adjust the vehicle
seat as far back as possible.
The car seat is exclusively made for forward facing car seats, which are
��
equipped with ISOFIX.
76 – 105 cm,
> 15 M
max. 18 kg
BASE Z2
BASE Z2
BASE Z2
BASE Z
BASE Z
EN
7