Securing The Child - Cybex Platinum Sirona Z2 i-SIZE Manual De Instrucciones

SECURING THE CHILD

1. Rotate the car seat to the boarding position.
2. Press the Belt adjustment button (23) and pull both Shoulder belts (24) at the
same time to loosen them.
3. Undo the Belt buckle (25) by pressing the red button firmly.
4. The Buckle tongues (26) can now be attached to the indicated places on the
cover using the integrated magnets.
5. Put your child in the car seat with their buttocks at the back.
6. Place the Shoulder belts (24) directly over your child's shoulders.
7. Place both Buckle tongues (26) together and lock them in place in the Belt
buckle (25). You should hear an audible "CLICK".
8. If you are using a seat with a SensorSafe Clip, push the clip closed until you
hear an audible "CLICK" and slide the closed clip down towards the Belt
buckle (25).
9. Tighten the Lap belts (27) and then pull on the Central adjustment belt (28) to
tighten the Shoulder belts (24) until they rest snug against your child's body.
The harness should be fitted tight enough so that it is not possible to put a fold
��
in any of the straps.
10. When using the SensorSafe clip, position the clip directly below the shoulder
pads.
11. Rotate the seat to the preferred travel position. Forward facing direction is only
permitted for children exceeding an age of 15 months and a size of 76 cm.
REMOVING AND REATTACHING THE SEAT COVER
The car seat cover consists of 5 parts. These are fastened to the car seat at
several places. Once unfastened, the individual parts of the cover can be removed.
To reattach the cover, follow the removal instructions in the reverse order.
If purchased with the Newborn inlay* (4), the foam must be removed before you
wash. There are openings in the fabric for this purpose.
The cover may only be washed at 30°C with a delicate wash program otherwise
��
it may result in discolouration of the cover fabric. Please wash the cover
separately from other laundry and do not dry it in the dryer or in direct sunlight!
*Extra equipment
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATION
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you 3 years
warranty on this product. The warranty is valid in the country where this product
was initially sold by a retailer to a customer. The contents of the warranty and all
essential information required for the assertion of the warranty can be found on
our homepage: go.cybex-online.com/manufacturer-warranty-car-seats. If a
warranty is shown in the article description, your legal rights against us for defects
remain unaffected.
Please observe the waste disposal regulations in your country.
EN
9