Troubleshooting, Causes, Solutions; Maintenance; Routine Maintenance; Chain Tension Adjustment Check - CAMPAGNOLA T-REX 160-240 Manual De Uso Y Mantenimiento

5.5

Troubleshooting, causes, solutions

FAULT
The tool
is not working
The tool has less cutting
force
The chain stops
The chain stutters while
cutting
Insufficient lubrication
The battery does not
charge fully
CAUTION!
Failure to comply with the instructions in the manual may cause damage or injury.

6 MAINTENANCE

6.1

Routine maintenance

CAUTION!
• Before carrying out any routine maintenance, switch off with the ON-OFF button (9), remove the battery (21)
from the tool and wear heavy-duty gloves.
All the maintenance operations which are not described in this manual have to be performed in Authorised
•
Service Centres.
The routine maintenance operations may be carried out by the operators.
6.1.1

Chain tension adjustment check

Periodically check the tension of the chain and adjust it if necessary, following the procedure shown in paragraph
4.1.2. The chain (1) has a tendency to expand or shrink when using the tool, changing its tension.
Do not tension the chain when it is elongated due to heat. Wait for it to cool down before adjusting it again.
IMPORTANT!
If the chain is new, it requires a break-in period during which its tension must be checked more often.
6.1.2

Check and replacement of the chain and/or cutting bar

NOTE!
Replace the chain when after sharpening it many times, the length of the tooth reaches 3-4 millimetres or
when the links of the chain are worn.
Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 11/04/2022
CAUSES
Low battery
Battery not connected
Potential electronic or mechanical
problem
Low battery
The chain is not sharp
The chain is too tight
Insufficient lubrication
Chain improperly tensioned.
Insufficient lubrication
The chain is worn out
The chain is damaged
Low oil level in the tank
Degraded battery
Faulty battery charger
Unsuitable battery charger
SOLUTIONS
Recharge the battery (21)
Check the tool for proper connection to the bat-
tery (21).
Take the tool to a Service Centre authorised by
the Manufacturer.
Recharge the battery (21).
Sharpen or replace the chain (1).
Adjust the tension of the chain (1).
Top up the oil in the tank.
Adjust the tension of the chain (1).
Top up the oil in the tank.
Sharpen the chain (1).
Replace the chain (1).
Top up the oil in the tank through the cap.
Replace the battery (21).
Replace the battery charger (23).
Make sure the battery charger (23) is the one
supplied with the product.
Page 47