Orbea BLUE PAPER URRUN 2022 Manual Tecnico página 13

24 | ORBEA
Disconnect the charger from the bicycle´s charging port by
carefully pulling from the charger´s connector. Make sure
the charging port´s cover is correctly closed.
While the charger is connected to Urrun, the bicycle can-
not be powered on. If you want to know the exact internal
battery level at a given time, disconnect the charger from
the bicycle and turn the bicycle on. You will be able to see the
battery charge level in the Shimano display.
Avoid discharging your battery repeatedly below 10%.
· Avoid leaving the charger connected to the bike con-
tinuously for extended periods of time and charge
your bicycle or battery in a place where you have
visual access to it so the charger can be disconnected
if any anomaly is detected, such as smoke, unusual
The RS Smart Charger has been designed to stop charg-
ing the battery when the charge is completed to avoid
damaging the cells for your peace of mind. However, it is
recommended to supervise the charge to avoid damages
due to a malfunctioning charger.
The lithium-ion batteries are sensitive to temperature dur-
ing the charging process. Observe the use, charge and
storage temperature ranges described in this manual.
RS RANGE EXTENDER BATTERY.
The Urrun Smart Charger is not compatible
with the Rise Carbon 2021-2022 internal
battery or Range Extender. The Rise Carbon
2021-2022 charger is not compatible with
the Urrun internal battery or Range Extender.
TECHNICAL MANUAL
Kemen, Urrun and Rise Hydro 2022 use the
same RS Smart Charger.
To charge the Range Extender, plug the RS charger into
the mains outlet. With the Range Extender not being con-
nected to the charger, the LED on the charger´s body will
blink in blue.
Disconnect the Range Extender connection cable to the
bicycle charging port (in case it is connected) by turning
pulling from the cable.
Connect the charger to the Range Extender correct-
ly aligning the connector pins with those of the Range
Extender´s charging port.
The charger´s body LED will turn blue for 2 seconds and
then it will start fading in and out cyclically until the bat-
tery is completely charged.
B LU E PA P E R U R R U N · 2022
When the battery is fully charged, the charger´s body LED
will light in blue permanently.
100%
While the Range Extender is being charged, the charge
indicator LEDs will show the current battery level. The
blinking LED shows the range (in 25% increments) that is
currently being charged.
When the battery is fully charged, disconnect the charger
from the charging port by carefully pulling from the charg-
er connector.
If you are going to use the Range Extender on the bicycle,
connect the Range Extender cable to the Range Extender
and the bicycle charging port with the safety tabs open
and, once the cable is correctly connected, turn the tabs
clockwise for a safe connection.
ORBEA | 25
Avoid discharging your battery repeatedly below 10%.
· Avoid leaving the charger connected to the bike con-
tinuously for extended periods of time and charge
your bicycle or battery in a place where you have
visual access to it so the charger can be disconnected
if any anomaly is detected, such as smoke, unusual
The RS Smart Charger has been designed to stop charg-
ing the battery when the charge is completed to avoid
damaging the cells for your peace of mind. However, it is
recommended to supervise the charge to avoid damages
due to a malfunctioning charger.
The lithium-ion batteries are sensitive to temperature dur-
ing the charging process. Observe the use, charge and
storage temperature ranges described in this manual.
Read the Relevant Information about the RS
Batteries of this manual for more detailed in-
formation on the use, care and troubleshoot-
ing procedures of the RS internal battery and
Range Extender.
EN