Maximum Tyre Width; Minimum Seatpost Insertion; Maximum Fork Length; Maximum Number Of Headset Spacers - Orbea BLUE PAPER URRUN 2022 Manual Tecnico

16 | ORBEA
0 4 U SE WAR N I N G S.
URR U N
M AXI MUM TY RE WI DT H
tyres that can be mounted on the frame. Always follow
these guidelines when installing tyres on your bicycle.
However, the real measurements of the tyre circumfer-
ence and width may change from one manufacturer to
another. When installing a tyre other than that originally
mounted on your Orbea bicycle, check that there is at
least 6 mm between the top and the sides of the tyre and
any part of the frame.
Damage to the frame or components due to
the use of a tyre that does not comply with
these measurements is not covered by the
warranty conditions.

MINIMUM SEATPOST INSERTION

the minimum insertion depth of the seatpost
or the frame on road bicycles with exclusive
Orbea seatposts. The failure to follow these
instructions can cause stresses on the ma-
terials beyond the conditions for which they
were designed and cause damage not cov-
ered by the warranty conditions, as well as
accidents that can result in serious injuries.
M AXI MUM FOR K LEN GT H
(AXL E TO CR OWN )
Always abide by the maximum fork length listed in the
imum fork length refers to the distance between the fork
axle and the bottom part of the head tube (axle to crown).
TECHNICAL MANUAL
The failure to abide by this measurement
and install forks with a length greater than
frame beyond its design characteristics,
possibly resulting in malfunctions of the
material that could cause accidents and se-
rious injuries.
L
MAXIMUM NUMBER OF HEADSET
SPACERS
Never use more headset spacers below the
maximum number of headset spacers that
are acceptable for use on an Orbea frame.
Installing more spacers than those permitted
-
can stress the materials beyond the use for
which they were designed, which can cause
accidents and serious injuries.
B LUE PAPER URRU N · 2022
P OSITIO N OF TH E STEM
ON THE FORK´ S STEERER TUBE
O.K.
NOT O.K.
The length of the fork steerer tube must al-
ways be appropriate for the position of the
stem in the fork. The stem must always be
installed in the steerer tube of the fork so
that both fastening bolts on the back of the
stem are positioned above the surface of the
- steerer tube of the fork. Never mount
the stem so that the top fastening bolt of the
stem remains above the top edge of the fork
steerer tube. This will stress the materials
beyond the use for which they were de-
signed, possibly causing accidents and se-
rious injuries.
ORBEA | 17
INT ENDED USE
The intended use of all models is ASTM Condition 3, that
includes Condition 1 and 2 as well as technical natural
trails with jumps and drops up to 61 com.
The use of a bicycle on this terrain requires technical skills
and may cause beginners to sustain injuries.
For information about all ASTM categories, consult the Ge-
neral User Manual.
EN