Automatic Mode; Settings In Automatic Mode - ROBBE POWER PEAK TRIPLE EQ-BID 8541 Manual De Uso

POWER PEAK TRIPLE EQ-BID
Important !!! Before connecting a battery it is absolutely essential to check one last time
that you have set the parameters correctly. If the settings are incorrect, the battery may be
damaged, and could even burst into flames or explode. To avoid short-circuits between
the banana plugs, always connect the charge leads to the charger first, and only then to
the battery. Reverse the sequence when disconnecting the pack.
Equalizer socket:
The voltage sensor lead attached to the battery must be connected to the charger with
the black wire aligned with the arrow marking. The arrow indicates the Earth (negative)
terminal. Take care to maintain correct polarity! (wiring diagram: see below.)
6.

AUTOMATIC MODE

This example is only a general guide, indicating how the voltage sensor lead should be
connected to the Equalizer.
EQ-Adaptor
robbe-PQ No.8213
the charger works in automatic mode, in which case all the parameters are optimised auto-
© robbe Modellsport
All manuals and user guides at all-guides.com
Operating instructions
If you press the 'AUTO' button from the Start screen,
EQ-Adaptor
robbe-JSTXH No.8214
matically.

6.2 SETTINGS IN AUTOMATIC MODE

9
Order No.
8541
VOLTAGE SENSOR
+
+S1
+
+S2
+S3
EQ-Adaptor
robbe-TP/FP No.8215
-
-