General Safety Notes; Guarantee - ROBBE POWER PEAK TRIPLE EQ-BID 8541 Manual De Uso

POWER PEAK TRIPLE EQ-BID
12.

GENERAL SAFETY NOTES

• The Triple EQ-BID is suitable solely for charging and discharging rechargeable NC / NiMH / Lead-
acid and Lithium batteries. Do not attempt to recharge dry cells - explosion hazard.
• The charger is designed solely for use with a 12 V DC power supply do not connect it to any other
voltage.
• Protect the charger from dust, dirt and damp.
• Do not subject the charger to excessive heat or cold, nor to direct sunlight.
• Avoid shock and pressure loads, and do not subject the charger to severe vibration.
• Never place the charger and the batteries connected to it on any form of flammable surface. Never
operate the charger in the vicinity of flammable materials or gases.
• Do not open the charger when it is connected to a power source.
• Do not leave the charger operating unsupervised. It is normal for the charger to become quite hot
when operating.
• Ensure that there is an unrestricted airflow to the charger's cooling slots.
• If you will not be using the charger for a protracted period, disconnect it from the power source and
any batteries connected to it.
• Never charge any battery a second time immediately after its initial charge.
• Do not charge a battery which is already warm or hot to the touch; allow packs to cool down to
ambient temperature before continuing.
• Packs to be charged as a unit must consist of cells of the same make, the same type and the same
capacity.
• Do not charge two batteries connected in parallel to one output; connect only one battery at a time.
• Take great care to maintain correct battery polarity, and avoid short-circuits.
• Read the battery manufacturer's instructions and adhere to them strictly.
• Always check the settings on the Compact 6S EQ Duo Power very carefully. Incorrect char-
ger settings can destroy batteries.
• At regular intervals check the charger case and cables for damage.
• Please take particular care when handling packs containing large numbers of cells. Ensure that the
cells are thoroughly insulated, otherwise there is a danger of electric shock.
• Read and observe the instructions provided by the battery manufacturer.
13.

Guarantee

We guarantee this battery charger for a period of 24 months. Proof for the start and finish of this
guarantee period is provided by your receipt from the model shop, which you obtained when you
purchased the product. Any repairs carried out under guarantee do not extend the original guarantee
period. During this period we will correct any operating faults, production defects and material faults
which arise, at no charge to you. We will not entertain any claims beyond these terms, e.g. conse-
quent damage.
Goods must be sent to us carriage-paid; return carriage will be paid by us. We will not accept non
carriage-paid shipments.
We accept no liability for transit damage and the loss of your shipment; we therefore recommend
that you take out suitable insurance to cover these risks. Send the unit to the Service Centre respon-
sible for the country where you live.
The following conditions must be fulfilled if we are to process your guarantee claim:
• Send proof of purchase (till receipt) with your shipment.
• The unit must have been operated in accordance with the operating instructions.
• The unit must have been operated with the recommended power sources and genuine robbe
accessories.
• The unit must not exhibit damage due to damp, unauthorised intervention, excessive voltage,
© robbe Modellsport
All manuals and user guides at all-guides.com
Operating instructions
22
Order No.
8541