Starting A Charge / Discharge Process - ROBBE POWER PEAK TRIPLE EQ-BID 8541 Manual De Uso

POWER PEAK TRIPLE EQ-BID
SETTING THE DISCHARGE CURRENT
Press the '+' button to leaf through the screen display until the arrow indicates Discharge
selection. The available discharge current range is 0.1 A to 1.0 A, although the maximum
current value varies according to the cell count and / or the battery voltage. The charger's
integral processor limits the maximum discharge current.
SETTING THE AUDIBLE SIGNAL
Press the '+' button to leaf through the screen display until the arrow indicates Beeper.
lable, and the beeper can also be switched off. Pressing the '+' or '-' button cycles through
the available sounds; at the same time the charger emits the corresponding sound once to
help you select your preference.
STORING THE SETTINGS
play, i.e. it returns to the starting point.
7.4 STARTING A CHARGE OR DISCHARGE PROCESS
using the '+' or '-' buttons; the new value flashes initially before the charger adopts it.
© robbe Modellsport
All manuals and user guides at all-guides.com
Operating instructions
Current. Press the 'ENTER' button and the '+ / -'
symbol flashes. You can now select the discharge
current in increments of 0.1 A using the '+' or '-' but-
ton. Press the 'ENTER' button again to confirm your
Press the 'ENTER' button and the '+ / -' symbol flas-
hes. You can now select the sound which the char-
ger emits, for example, to alert you that the charge
process is finished. Five different sounds are avai-
Press the '+' button to leaf through the screen dis-
play until the arrow indicates End, then press the
'ENTER' button to store the settings you have just
entered. The screen now reverts to the Start dis-
• Press 'MAN', and the Start display appears.
• Press 'ENTER' to prepare the displayed memory
for the charge process.
• Select the desired process by pressing the 'MODE'
button.
• In the interests of safety the screen displays the
stored parameters again.
• Press the 'START' button to initiate the charge
process; an audible beep confirms your action. The
screen now changes to a working display, which
shows all the important parameters (see Chapter
5.1).
• During the process you can change the current
15
Order No.
8541