Reading Out The Data On A Bid Chip / Key; Charge / Discharge Processes With A Bid Chip / Key - ROBBE POWER PEAK TRIPLE EQ-BID 8541 Manual De Uso

POWER PEAK TRIPLE EQ-BID
You will now hear a double beep to confirm that the changes have been stored successful-
ly. If you do not wish to accept the new data, you must answer 'NO' to the security query.
In either case the start display for the programming procedure re-appears.
8.3 READING OUT THE DATA ON A BID CHIP / BID KEY
If you have a battery with a BID chip and connect it to the charger, the following battery
data can be read out to give you an accurate display of the battery's state.
9.

CHARGE / DISCHARGE PROCESSES WITH A BID CHIP / KEY

BID chip / keys are so small that you can slip them into whatever other accessories you
are using. The pictures on the next page show how BID chips are used.
© robbe Modellsport
All manuals and user guides at all-guides.com
Operating instructions
When you have finished entering the parameters,
you must conclude the procedure by pressing the
'ENTER' button once more; this stores the new
values permanently in the BID chip. If data has
been changed during the entry procedure, the
screen first displays a security query: to store
the data you have to change the answer to 'YES'
using the '+' or '-' button, and then press the
'ENTER' button.
Data is stored on the BID chip / BID key, and can
be read out.
Pressing the '+' button twice displays the first
parameter on the screen: this is the capacity of the
current charge or discharge process.
Pressing the '+' button twice more displays the
second parameter on the screen: this is the maxi-
mum capacity value from all charge / discharge
processes.
Pressing the '+' button twice more displays the final
parameter: this is the number of charge cycles and
the programmed date.
18
Order No.
8541