GYS STARTFLASH 120.24 CNT Manual De Uso página 24

User manual
Power limitation : If the ʺ*ʺ symbol appears next to the electrical-current settings (e.g. I: 50A*), this means that the charger is not
be able to deliver this current level at the voltage specifed on the screen. Because at this voltage, the charger will be at its maxi-
mum power. However, this current may be delivered for lower voltages, depending on the charger's power limitation.
• Starting the charging process:
To start charging, use the turn dial to move to the arrow at
the top right of the screen and press the turn dial.
1
If the Auto-Detect feature is active, the charging process
will automatically start after the battery has been connec-
ted for five seconds.
Scrolling through sections (using the turn dial) provides
further information during the charging process:
2 1 - The injected voltage, current and ampere hour as well
as the duration of the current operation.
3 - The current charging parameter settings.
To stop charging, press the turn dial. Move the cursor to
3
, then, press the turn dial again.
Warnings:
When starting the mode, a current reading of more than 10 A means that your battery is discharged. Your STARTFLASH will then
deliver a charging current. Check that there are no electrical consumers on the vehicle. Wait until the current drops below 10 A
before starting any procedures on the vehicle (using the vehicle's electrical devices or diagnostic procedures, etc.).
Power-supply mode features:
Mode No-battery feature
SHOWROOM
DIAG+
• No battery feature (not recommended):
This feature allows the SHOWROOM power mode to be used without a battery. To do this, go into
SHOWROOM mode and set the parameters in the usual way. Move the cursor over the arrow in the
same way as when launching standard charging, however, keep the turn dial pressed down for three
seconds to start the charging process. The No-battery feature message is displayed for three seconds
before the power is forced on.
It is not recommended to use the no-battery feature if a battery is installed.
This function disables the built-in charging feature as well as certain safeguards, such as abnormal un-
dervoltage protection or disconnection detection.
In this configuration, reversed polarity can damage the vehicle's electronics.
• Built-in charging feature:
SHOWROOM mode (excluding the no battery feature) has an automatic charging algorithm for all battery types (lead and lithium)
to ensure that demonstration vehicles are kept at an optimal charging level. This feature is perfectly compatible with the battery's
electrical consumers.
24
Translation of the original user manual
Built-in charging feature
BSU
1 2 V
13.5 V
1
Abnormal undervoltage
protection
STARTFLASH CNT
2
Voltage adjustment
to be regulated
6.3 - 7.2 V
12.7 - 14.4 V
25.4 - 28.8 V
12.7 - 14.8 V
25.4 - 29.6 V
3s
BSU
1 2 V
13.5 V