GYS STARTFLASH 120.24 CNT Manual De Uso página 32

User manual
TRACEABILITY
The device can retrieve the history and data of over 1000 load launches + 1000 BSU cycles onto a USB key and use it in a spread-
sheet.
Browsing and exporting charging data to a USB key:
This feature allows the history and load data to be viewed and retrieved from a USB memory key for use on a computer spread-
sheet or other electronic device.
1 Go to the cable trac eability menu.
2 Press ʺ Explore ʺ to v iew the stored charging data.
3 Press ʺ Export ʺ to ex port the recorded charging data.
4 Plug the USB key into the STARTFLASH device.
5 The charger will automatically copy the charging data to the USB key as a ʺ .CSV ʺ file.
CONNECTIVITY MODULES
Your STARTFLASH is equipped with a DB9 socket; this allows you to connect various additional modules offered by GYS, such as a
printer module, Ethernet or other modules in order to extend your charger's capabilities.
ERROR CODE LIST
Error code
Err01: Int_1 - Err02: Int_2
1
Err23: Int_3 - Err24: Int_4
2 Err03: Fuse_NOK
3 Err04: T > Tmax
4 Err05: (+) (-)
5 Err06: U>__V
6 Err07: No_bat
7 Err08: U<__V
8 Err09: U>__V
9 Err10: U>2.0V
32
Translation of the original user manual
Meaning
Electronic problem
Faulty charger
HS output fuse
Excessive heat
Reverse polarity on the clamps
Overvoltage detected at clamp termi-
nals
Battery not connected
Abnormally low battery voltage
Unusually high battery voltage
Short circuit detected during charging
Solutions
Contact the distributor
Have the fuse replaced by a qualified technician.
Contact the distributor
Connect the red clamp to the battery's positive terminal (+) and
the black clamp to the negative termainl (-).
Disconnect the clamps
Check that the battery is properly connected to the charger
Check that the selected mode is compatible with the battery's
voltage level (e.g . 6 V battery on 24 V charging mode)
Charge the battery using the charging mode
Battery to be replaced
Check that the selected mode is compatible with the battery's
voltage level (e.g . 24 V battery on a 12 V charging mode)
Check the set-up
STARTFLASH CNT