STAMOS S-LS-88 Manual De Instrucciones página 35

CH1 refers to the provision of constant power at the output.
LIST refers to the provision of dynamic/sequential values. If LIST is
selected, 1-LIST is given.
Similarly CH2 – channel 2; CH3 – channel 3; CH4 – channel 4
11 – Indication of output voltage referring to channel 1
12 – Indication of output current referring to channel 1
13 – Indication of output power referring to channel 1
14 – Output current and output voltage stabilisation settings for channel 1. If
they are active, the message "ON" will be displayed. If they are inactive, the
message "OFF" will be displayed
15 – OVP and OCP. Fuse settings are disabled, the message "OFF" will be
displayed. Fuse settings are active, the implemented value will be displayed
16 – Current and voltage settings for channel 1
17– Channel 1. Test data reading for CH1 1-LIST
18 – Channel 2. Test data reading for CH2 2-LIST
19 – Channel 3. Test data reading for CH3 3-LIST
20 – Channel 4. Test data reading for CH4 4-LIST
21 – Function configuration key
22 – USB link identification indicator When the USB drive is connected, the
message "USB" will be displayed
3.3.2. REAR PANEL – INTRODUCTION
23 – Power supply cable connection socket
24 – External control port
25 – External control port
26 – Voltage outputs for channels 1–4. GND terminal – ground
27 – USB cable connection socket
28 – RS-232 cable connection socket
29 – LAN cable connection socket
30 – GPIB cable connection socket