Working With The Device - STAMOS S-LS-88 Manual De Instrucciones

5 – Laboratory cable
6 – GPIB cable
7 – Software CD
8 – Power supply cable
9 – USB cable
3.2. Preparation for work
LOCATION OF THE DEVICE
Position the device in a way that allows for good air circulation. Maintain a minimum
distance of 10 cm from any wall. Keep the device away from any hot surfaces.
Always operate the device on a level, stable, clean, fireproof and dry surface and
out of the reach of children and persons with reduced mental, sensory and
intellectual abilities. Position the device in such a way that the power supply plug
can be reached at any time. Make sure that the device's power supply corresponds
to the data on the rating plate!

3.3. Working with the device

Before starting work with the device, connect the necessary power cables of the
device and test components. Refer to the device parameters. After starting with
the "POWER" switch (8), set the desired parameters as described below. After the
end of use turn off the device with the "POWER" switch (8). Disconnect the external
components and the device plug from the power supply.