Teac AG-D9100 Manual Del Usuario página 21

Delay Time/Effect
POWER ON
1. The delay time can be simultaneously set for the
DOLBY DIGITAL/DOLBY PRO LOGIC modes using the
DELAY TIME (¶/§) buttons. When you adjust the
delay time in the DOLBY DIGITAL mode, an addition-
al 15 ms is automatically added to the surround chan-
nels in the DOLBY PRO LOGIC mode. The current set-
ting is shown on the display.
Delay Time Setting
Surround Mode
DOLBY DIGITAL
DOLBY PRO LOGIC
In the surround modes, the sound from the rear speak-
ers should be delayed slightly, relative to that from the
front speakers. The optimum delay time will depend on
acoustic properties, whether the walls and furnishings
reflect or absorb sound, etc.
It is recommended that you try different delay times to
obtain the best effect. The delay is digitally synthesized,
for the highest sound quality with minimum noise and
distortion.
The delay time can be set independently for each
surround mode using the DELAY TIME buttons, with the
current setting shown in the display.
2. In the general surround (HALL, THEATER, DISCO,
STADIUM) mode, set the EFFECT as you desire.
The EFFECT refers to the strength of sound and size
of sound field.
EFFECT range is "1 – 9".
1, 2
Adjustable Range
0 – 15 ms in 1 ms step
15 – 30 ms in 1 ms step
Channel Level
POWER ON
Test tones are automatically emitted from the different
speakers. Listen to the test tone and adjust the volume
level of each speaker so that they produce the test tone
at the same volume level.
1. Press the TEST TONE button.
The test tone is emitted from each speaker in the fol-
lowing order at 2-second intervals.
„ ∑ L „ ∑ C „ ∑ R „ ∑
2. Each press of the LEVEL TRIM button during test
tone emission allows you to manually skip to the
speaker you want to listen to.
3. Use the SELECT (¶/§) buttons to adjust the volume
until the sound level from each speaker is the same.
The volume can be adjusted in units to 1 dB from –10
dB to +10 dB.
4. Press the TEST TONE button again to turn it off.
Notes:
If certain speakers are not being used, (for example,
no center speaker) the noise sequencer will automati-
cally skip over that channel.
Press the LEVEL TRIM button for more than 2 sec-
onds to reset the level to its original setting.
– 21 –
1,4 2 3
RS „ ∑ LS „ ∑ SUB „