Connections; Connecting Audio Equipment - Teac AG-D9100 Manual Del Usuario

CONNECTIONS

CAUTION:
Do not plug the power cord of any component into AC
outlets and do not turn their POWER switches on until
all connections have been performed.
The cable connectors should be fully inserted into the
jacks. Loose connections may cause hum and noise.
Read the instructions for each component you intend
to use with the receiver.
Refer to "Connecting Antennas" on pages 6~7.
CD Player
Turntable
+ –
Center
Right
Left
Speaker
Rear Speaker
Audio connection cords
White
L
R
Red
To make these connections, use interconnect cords with RCA plugs.
Make sure that you connect the white pin-plug to the white jacks
(left) and the red pin-plug to the red jacks (right).
MD Deck or Tape Deck
LINE OUT
LINE IN
Tape Deck
White White
Red Red

Connecting Audio Equipment

AUDIO signal jacks
PHONO jacks
Connect the turntable's output jacks to the PHONO IN
jacks.
CD IN jacks
Connect the CD player's output (LINE OUT) jacks to the
CD IN jacks.
MD/TAPE 1 (PLAY/REC) jacks
Connect the MD/TAPE1 jacks to the MD player or the cas-
sette deck.
... Connect the MD player or cassette deck output (LINE
OUT) jacks to the PLAY jacks.
... Connect the MD player or cassette deck input (LINE
IN) jacks to the REC jacks.
TAPE 2 (PLAY/REC) jacks
... Connect the cassette deck output (LINE OUT) jacks to
the PLAY (TAPE 2 MONITOR) jacks.
... Connect the cassette deck input (LINE IN) jacks to the
REC (TAPE 2 MONITOR) jacks.
Right Right
Left
Front B Speaker Front A Speaker
L
R
– 3 –
Left