Connecting The Pre Out Jacks - Teac AG-D9100 Manual Del Usuario

Connecting the PRE OUT jacks

By connecting an external power amplifier, you can
increase the number of available outputs and the output
levels. When an external power amplifier is connected,
be sure to connect the speakers for each amplifier.
Since subwoofer signals are not amplified, use a sub-
woofer with a built-in amplifier or connect it to the ampli-
fier connected to this unit.
Front Speaker
Left Right
Power Amplifier
or
Subwoofer with
built-in amplifier
Notes:
... If a speaker is connected directly to the PRE OUT jack
... When the STEREO mode is selected, no signal is out-
Rear Speaker
Left Right
Power Amplifier
Power Amplifier
SWITCHED:
These outlets are only active when the receiver is
turned on.
Caution:
Subwoofer without
amplifier
– 5 –
without an amplifier connected, no sound comes
from the speaker.
put from the SUBWOOFER PRE OUT jack.
Center Speaker
AC OUTLETS
Make sure that the total power consumption of all
equipment connected to the outlets on the receiver
does not exceed 100 watts.
Power Amplifier
To AC outlet