Preset Tuning - Teac AG-D9100 Manual Del Usuario

Preset Tuning

This facility is used to store FM, AM broadcasting from
Channel 1 to 30 respectively.
Automatic Memory Presetting
1
POWER ON
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the MEMORY button for a while (for more than
1.5 seconds).
1 The start frequency will show in the display.
87.5 MHz in FM, 522 kHz in AM.
2 The frequency and display will automatically scan.
50 kHz steps for FM, 9 kHz steps for AM.
3 The frequency shown in the display will rapidly
change. As each station is located a preset
number will appear in the display indicating which
preset MEMORY button has been assigned to the
station located. The scanning process will contin-
ue to operate in this fashion until 30 stations have
been found and entered into the preset memory
or when there are no more stations to be found
on the waveband chosen. The memory indicator
will extinguish and let you hear the last station to
be memorized.
To listen to the memorized station select the band
required and press the numeric keys 1, 2, 3 etc.
4. The last memorized channel of each band will be
displayed when Auto Memory is completed. Check
the programmed frequencies with PRESET UP,
DOWN button.
4 2
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
3
3. Press the MODE button to change to TUNING mode.
4. Select the frequency you want to preset by pressing
5. Press the MEMORY button briefly, MEMORY display
6. While the MEMORY indicator is lit, press the numeric
Press the numeric key(s) corresponding to the channel
number to tune directly to a broadcast.
When the MEMORY SCAN button is pressed, the preset
channels in which frequencies in the band (AM or FM)
selected have been stored are scanned at 5-second
intervals. When you hear a broadcast you want to listen
to, release the Memory Scan function by pressing the
MEMORY SCAN button again.
This function conserves the already preset station mem-
ories, and "Most-recent" memory function, even in the
event of a cut-off of power supply, as when the plug is
pulled out of the wall outlet, for 3 days.
– 13 –
Manual Memory Presetting
1 6
POWER ON
button.
(The PRESET CH. indicator disappears from the
display.)
TUNING/PRESET UP or DOWN button.
will blink at an interval of 1 second.
key(s) to input the channel number in which the data
(AM or FM band and frequency) for the broadcast is
to be stored (or press the PRESET button then press
the MEMORY button again).
Recalling Frequencies
Using the Memory Scan function
"Back-up" memory function
2
5 3 4,6