Video Operations; Playing Video Sources; Recording With A Video Deck - Teac AG-D9100 Manual Del Usuario

VIDEO OPERATIONS

Playing Video Sources

Note:
For playing video software using a certain Surround
Effect function, refer to the SURROUND EFFECTS
section.
1
Source Indicators Lit
POWER ON
2
VIDEO 1
VIDEO 2
VCR/VIDEO 4
3
TV Monitor
1. Select the VIDEO 1, VIDEO 2, VIDEO 3 or VCR/VIDEO 4
mode by turning the FUNCTION selector.
2. Play the component corresponding to the FUNCTION
selected.
3. The picture from the video source can be seen on the
TV and the sound from the video source will be
heard from the speakers.
: Video signals
: Audio signals
2
VIDEO 3
3
Speakers
– 18 –

Recording with a Video Deck

Tape Dubbing (from VIDEO 1, VIDEO 2 or
VIDEO 3 to VIDEO 4)
1
TAPE 2 MONITOR OFF
POWER ON
3
VIDEO 4
Recording
1. Turn the FUNCTION (source) selector to select the
VIDEO source (VIDEO 1, VIDEO 2 or VIDEO 3) to be
recorded.
Make sure the TAPE 2 MONITOR button is set to
OFF.
2. Play back the source (VIDEO 1, VIDEO 2 or VIDEO 3).
3. Operate VCR/VIDEO 4 for recording. Video/audio sig-
nals from the selected VIDEO component (VIDEO 1,
VIDEO 2 or VIDEO 3) can be dubbed to VCR/VIDEO 4.
Note:
When tape dubbing is performed, be sure to connect
the LINE OUT (analog audio output).
S.A.V.E. (Second Audio Source for Video
Editing) SYSTEM Function
This feature lets you replace the sound from a VCR with
sound from an AUDIO source such as CD during video
signal dubbing.
1. Select the video source (VIDEO 1, VIDEO 2 or VIDEO
3) by turning the FUNCTION selector. Wait for more
than 5 seconds and then select the audio source with
the FUNCTION selector.
2. Operate the selected video component and audio
component for playback, respectively.
3. Now you can watch the picture from the video com-
ponent on the TV, and listen to the sound from the
audio component through the speakers.
4. Operate VCR/VIDEO 4 for recording.
: Video signals
: Audio signals
2
VIDEO 1
2
VIDEO 2 VIDEO 3
Playback Playback