Sage the Barista Express Impress SES876 Guía Rápida página 22

Ocultar thumbs Ver también para the Barista Express Impress SES876:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 146
CLEANING THE TAMP SYSTEM
1
2
Remove
Clean the chute
tamp cover
with brush
4
5
Release lever
Replace
tamp cover
• Remove the tamp cover.
• Brush clean the tamp face and cradle from any
dust or grinds.
• Push down and hold the lever down, using the
tamp cleaning brush, dust off grind residues in
and around the tamp.
• Slowly release the lever back up making sure
the cleaning brush is clear and out of the tamp
system area.
CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand with
a damp cloth. Then with the steam wand tip
directed over the drip tray, briefly set the
STEAM / HOT WATER dial to the STEAM
position. This will clear any remaining milk
from inside the steam wand.
• If any of the holes in the tip of the
steam wand become blocked, ensure the
STEAM / HOT WATER dial is in the
STANDBY position. Press the POWER button
to switch the machine off and allow to cool. Use
the pin on the end of the provided cleaning tool
to unblock the hole(s).
• If the steam wand remains blocked, remove the
tip using the integrated spanner in the cleaning
tool and soak in hot water. Use the pin on the
end of the provided cleaning tool to unblock the
hole(s) before re-attaching to the steam wand.
22
CLEANING THE FILTER BASKETS
AND PORTAFILTER
3
• The filter baskets and portafilter should be rinsed
• If any of the holes in the filter basket become
Push down lever
• If the hole(s) remain blocked, dissolve a cleaning
• Rinse thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
• Periodically purge the machine. Place an empty
• Press and hold the 1 CUP button and run a short
CLEANING THE DRIP TRAY &
STORAGE TRAY
• The drip tray should be removed, emptied, and
• Remove the grid from the drip tray. Lift the coffee
• The storage tray (located behind the drip tray)
All parts should be cleaned by hand using warm
water and a gentle dish washing liquid. Do not
use abrasive cleansers, pads or cloths which
can scratch the surface. Do not clean any of the
parts or accessories in the dishwasher.
under hot water immediately after use to remove
all residual coffee oils.
blocked, use the pin on the end of the provided
cleaning tool to unblock the hole(s).
tablet in hot water and soak filter basket and
portafilter in solution for approx. 20 minutes.
should be wiped with a damp cloth to remove
any ground coffee particles.
filter basket and portafilter into the group head.
flow of water to rinse out any residual coffee.
cleaned at regular intervals, particularly when the
drip tray full indicator is showing EMPTY ME!
grind separator and dispose of any coffee
grounds. The EMPTY ME! indicator can also be
removed from the drip tray by pulling upwards to
release the side latches. Wash all parts in warm
soapy water with a soft cloth. Rinse and dry
thoroughly.
can be removed and cleaned with a soft, damp
cloth. Do not use abrasive cleansers, pads or
cloths which can scratch the surface.
NOTE

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido