Sage the Barista Express Impress SES876 Guía Rápida página 26

PROBLEM
Hot water isn't
continuously flowing
Lever very hard
to tamp
Puck surface is not
flat and smooth
Puck surface has some
loose grounds on top
Tamp height is not
at desired level
Tamp light continues
to flash and no height
reading on gauge
after tamping
When maintenance
light indicator
flashes
When maintenance
light indicator
illuminates solid
* Razor – See accessories list under
26
POSSIBLE CAUSES
•
Machine is too hot after
steaming.
•
Severe overdose.
•
Coffee build-up in mechanism.
•
Coffee grinds stuck on tamp
face.
•
Coffee grinds caught on tamp.
•
Coffee grinds caught on tamp
from tamping too quickly.
•
Machine is on auto mode, that is
for ideal height only.
•
Tamping action is not completed. Push the tamp lever down until you hear the beep.
•
Cleaning cycle is required.
•
Descale cycle is required.
Components.
WHAT TO DO
Allow machine to cool down.
Use the Razor trimming tool* to correct current dose.
Select the correct filter size.
Remove shroud (tamp) cover and clean using the
cleaning brush provided.
Remove shroud (tamp) cover and clean using the
cleaning brush provided.
Push the tamp lever again for a very polished
coffee puck.
Push the lever down slower.
Use 'Manual' mode for custom control.
The maintenance light indicator
when a cleaning cycle is required.
Go to Care & Cleaning section for cleaning and
descaling instructions.
The maintenance light indicator
when a descale cycle is required.
Go to Care & Cleaning section for cleaning and
descaling instructions.
will flash
is on solid light