Riving Knife - Mafell PSS 3100 SE Instrucciones De Funcionamiento Y Seguridad

PSS 3100 SE

4.6 Riving knife

The riving knife prevents the saw blade from jamming during rip cutting. In addition, the riving knife retracts into
the machine during plunge cuts. This prevents kickback during the sawing process.
The correct distance to the saw blade is shown in the figure.
Use the following procedure to adjust the
distance of the riving knife:
1. Pull out the power plug of the machine.
2. Set the unit to its greatest cutting depth.
See also chapter 5.6 Cutting depth setting.
➢
3. Adjust the screw 15 by turning it
counterclockwise with the Allen key B.
4. Move the riving knife along its longitudinal slot
to adjust it.
Do not exceed the maximum distance to
➢
the saw blade (see Fig.. 8).
5. Then re-tighten screw 15 by turning it
clockwise with the Allen key B.
The riving knife distance is set.
✓
01/2022
Fig. 8: Distance riving knife to saw blade
19