Setting The Feed Speed; Switching Off - Mafell PSS 3100 SE Instrucciones De Funcionamiento Y Seguridad

PSS 3100 SE
Material
Plastic material (styrofoam)
Plastic material (styrofoam)
Hardwood, softwood, laminated wood, wood-fiber insulation material
Hardwood, softwood, laminated wood, coated panel material
Hardwood, softwood, laminated wood, coated panel material, fiber cement
board
Hardwood, softwood, laminated wood, overlaid panel materials, fiber-cement
panels, soft fiber

5.4 Setting the feed speed

The feed speed can be continuously adjusted between 4 and 20 m/min [13.12 - 65.62 ft/min].
Use the following procedure to adjust the feed
speed:
1. Set the desired feed speed with the rotary
switch 1.
Turning the rotary switch counterclockwise
➢
turns the feed off.
✓ The feed speed is set.
A diagram attached to the control panel shows suitable "material – saw blade – feed speed"
combinations.
Use it for reference when setting the feed speed.

5.5 Switching off

Use the following procedure to switch off the
machine:
1. Release the rocker switch 3.
➢ Feed and saw blade drive are switched off
immediately.
The saw blade comes to a standstill in less
➢
than 10 seconds.
✓ The machine is switched off.
01/2022
Fig. 11: Setting the feed speed
Fig. 12: Switching the machine off
Step Rotational speed
rpm
1 2600
2 3150
3 3700
4 4200
5 4650
6 5200
21