Service And Maintenance; Machine Maintenance; Storage - Mafell PSS 3100 SE Instrucciones De Funcionamiento Y Seguridad

6

Service and maintenance

MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Machine maintenance

Regularly clean the machine from deposited dust (do so daily when cutting gypsum fiber board).
Clean the joints and guide parts, especially those in the guide rail and the motor's ventilation openings, with a
vacuum cleaner. Occasional spraying with machine oil maintains the smooth movement of the joints and
guiding parts.
Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.

6.2 Storage

Damaging the machine by bending the guide rails
Transporting or storing the machine with the guide rail extension attached may bend and deform the guide
rails.
Always remove the guide rail extension when transporting or storing the machine.
➢
We recommend leaning the panel saw system with the saw unit in its starting position vertically against the wall
for space-saving storage. The edge of the control panel used to put down the machine has a non-slip covering.
30
Notice
PSS 3100 SE
01/2022