Troubleshooting - Mafell PSS 3100 SE Instrucciones De Funcionamiento Y Seguridad

7

Troubleshooting

Some of the most common malfunctions and their causes are listed below. For other malfunctions, please
contact your dealer or MAFELL Customer Service directly.
Malfunction
Machine can not be switched on
Machine stops during the cutting
process
The feed drive does not switch off
when the end position is
approached
The feed speed cannot be
regulated
32
Warning
Risk of injury from a sudden start of the machine.
There is a risk that the machine starts suddenly due to carelessness when
working with the machine or during troubleshooting. The rotating saw blade can
cause serious injuries.
Determining the causes of existing malfunctions and their elimination
➢
always require increased attention and caution!
Pull out the mains plug before you start troubleshooting!
➢
Cause
Mains voltage missing or too low
Mains fuse defective
Carbon brushes worn out
The saw unit has pushed against
the limit switch on the stop slide or
on the control panel
Limit switch on the stop slide or
control panel is defective
Mains failure
Machine overload
Carbon brushes worn out
Cutout switch on the stop slide or
control panel is defective
Control (e.g. rotary switch)
defective
PSS 3100 SE
Elimination
Have the power supply checked by
an electrician
Have the fuse replaced by an
electrician
Take the machine to the MAFELL
customer service workshop
Initiate a reverse feed movement
Take the machine to the MAFELL
customer service workshop
Have the mains back-up fuses
checked by an electrician
Reduce feed rate
Take the machine to the MAFELL
customer service workshop
Take the machine to the MAFELL
customer service workshop
Take the machine to the MAFELL
customer service workshop
01/2022