Chip Extraction - Mafell PSS 3100 SE Instrucciones De Funcionamiento Y Seguridad

PSS 3100 SE

4.3 Chip extraction

For all work that produces a significant amount of dust, connect the machine to a suitable external extraction
device. The air velocity must be at least 20 m/s [65 ft/sec].
The inner diameter of the hose connector is 35 mm [1.4 in].
Operation without an extraction system is not
recommended.
Remove the connecting hose 10 between the saw
unit and the chip discharge channel (see illustration) if
you don't use an external extraction system and work
outdoors or in adequately ventilated rooms.
This avoids clogging the chip discharge channel in
the guide rail when operating without an extraction
system.
01/2022
Caution
Health hazards from wood dust
The dusts produced during work can be inhaled and can cause health damage.
Harmful dust must be extracted with a HEPA 13 dust extractor.
➢
➢ Wear a dust mask during work.
Fig. 3: Connection hose between saw unit and chip
discharge channel
15