Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
revised 03/2018
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank, debris collection grid and vacuum grid with float
cleaning, and cover gasket check
EcoFlex system cleaning and draining
Squeegee blade check and replacement
Solution filter cleaning
Vacuum system motor filter cleaning
Battery (WET) fluid level check
Cleaning the external dust around each motors
Electromagnetic brake efficiency check
Brushes motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) This maintenance procedure must be performed by a Advance authorized Service Center.
MACHINE WORKING HOUR CHECK
1.
Insert the ignition key (58) and turn it to "I".
2.
In the first 2 seconds of machine operation, the display (71) shows the total number of working hours (scrubbing/drying)
performed by the machine.
Turn the ignition key (58) to "0".
10/2010
INSTRUCTIONS FOR USE
Daily, after using
Weekly
the machine
9098827000 - SC3000 26 D
ENGLISH
Every six
Yearly
months
(1)
(1)
(1)
(1)
21
Publicidad
Tabla de contenido
