Scrapping - Nilfisk Advance SC3000 Instrucciones De Uso

ENGLISH
TROUBLE
The dirty water vacuuming is insufficient.
The solution flow is insufficient.
The squeegee leaves marks on the floor.
NOTE
The machine cannot operate without the battery charger.
In case of battery charger malfunction, contact an authorized Service Center.
For further information, refer to Advance Service Centers.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
Machine material composition and recyclability
Type
Aluminium
Electric motors - various
Ferrous materials
Wiring harness
Liquids
Plastic - non-recyclable material
Plastic - recyclable material
Polyethylene
Rubber
28
INSTRUCTIONS FOR USE
The recovery tank is full.
The vacuum grid is clogged or the float is
closing.
The container with debris collection grid is
clogged.
The hose is disconnected from the squeegee
The squeegee is dirty, or the squeegee blades
are worn or damaged.
The tank cover is not properly closed, or the
gasket is damaged.
The solution tank is empty.
The solution filter is dirty
The EcoFlex system tank is dirty/encrusted.
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee is not balanced with the
handwheel.
SC3000 26 D - 9098827000
POSSIBLE CAUSE
Recyclable
percentage
100 %
29 %
100 %
80 %
100 %
0 %
100 %
92 %
20 %
REMEDY
Empty the tank.
Clean the vacuum grid.
Clean.
Connect.
Clean the squeegee or overturn/replace the
blades.
Correctly close the cover or clean/replace the
gasket.
Fill.
Clean the filter.
Drain.
Remove the debris.
Overturn or replace the blades.
Adjust the squeegee.
Machine weight percentage
9 %
18 %
42 %
3 %
0 %
3 %
1 %
23 %
1 %
revised 03/2018
10/2010