Before Start-Up - Nilfisk Advance SC3000 Instrucciones De Uso

ENGLISH

BEFORE START-UP

WARNING!
At every machine start-up, check that, between the deck (10 and 28) and the machine or between the squeegee
(30) and the machine, there is no foreign material which may prevent the deck and the squeegee from lifting.
This check is necessary because, if the machine has been turned off without lifting the deck and the squeegee,
when turned on again, the deck and the squeegee lift automatically.
Brushes installation/removal
According to the kind of cleaning to be performed, the machine can be equipped either with brushes (A, Fig. 1) or pad-holders (B)
with pads (C) together with the appropriate deck.
For the installation/removal, proceed as follows.
1. Insert the ignition key (58) and turn it to "I".
WARNING!
Before pressing the One-Touch push-button (67), always check that, between the deck (10) and the machine
there is no foreign material which may prevent the deck from lifting.
2. Lift the deck by pressing the One-Touch push-buttons (67).
3. Turn the ignition key (58) to "0" and remove it.
4. Install the brushes/pad-holders (A or B) in the drive hub (D) under the deck, then turn them in the opposite direction to their
rotation direction, until they reach the end of stroke (E).
5. To remove the brushes perform steps 1 to 3, then manually release the brush from the hub by turning it abruptly in its normal
rotation direction (F).
WARNING!
If the machine is not perfectly assembled it can cause damages to people and properties. Always check that all
components are assembled before starting the machine. Carefully inspect the machine before using it.
D
A
E
14
INSTRUCTIONS FOR USE
D
A
F
F
SC3000 26 D - 9098827000
Front
B
E
C
Figure 1
revised 03/2018
B
C
P100362
10/2010