Skil PWRCORE 20 IW5761B-00 Manual Del Usuario página 13

Halo Light (Fig . 5)
Your tool is equipped with a halo light, located
on the head of the tool. This provides additional
light without shadows on the surface of the
work piece for operation in lower-light areas.
The halo light will turn on with a slight squeeze
on the variable-speed trigger switch before the
tool starts running. And automatically turns off
about 10 seconds after the trigger switch is
released.
NOTICE: When the tool and/or battery pack
becomes overloaded or too hot, the internal
sensors will turn the tool off. If the tool and/or
battery pack are overloaded, the halo light will
flash rapidly. Rest the tool for a while or place
the tool and battery pack separately under air flow to cool.
The halo light will flash more slowly to indicate that the battery is at low-battery capacity.
Recharge the battery pack.
Change the Work Modes
The mode panel (Fig. 6) on the foot of the tool
allows you to choose a desired work mode.
Whether the tool is set to reverse rotation, the
work mode – a combination of rotation speed,
impact rate, and torque – can be changed to
allow tightening or a loosening force suitable to
the work at hand.
You can change impact force by pressing the
speed button when the tool is set to either
rotation direction. And press the mode button
to toggle between normal loosening mode,
reverse control mode (RM) and nut busting
mode (NB) when the tool is set to reverse
rotation.
Speed Button
1 2 3
Fig . 5
Halo Light
Fig . 6
S
SPEED
RM NB
Mode Button
MODE
M
1 2 3
13