Skil PWRCORE 20 IW5761B-00 Manual Del Usuario página 16

Installing and Removing the
Impact Socket (Fig . 8)
Your tool is equipped with a quick-change
square drive, making socket installation and
removal quick and easy.
Lock the trigger switch "OFF" by placing the
direction-of-rotation selector in the center
position.
NOTICE: Make sure that the impact socket
and the mounting portion are not damaged
before installing the impact socket.
To install the Impact Socket:
a. Align the square of the impact socket with
the square drive and push the impact socket
onto the square drive until it locks into place.
b. Tap it lightly if required.
To remove the Impact Socket:
a. Simply pull the impact socket off from the square drive.
WARNING
hot after prolonged use.
Tightening and Loosening Nuts and Bolts
To tighten nuts and bolts
Variable-speed control must be used with caution for driving nuts and bolts using socket-
set attachments. The best technique is to start slowly, increase speed as the nut or bolt runs
down, and then set the nut or bolt snugly by slowing the tool to a stop. If this procedure is
not followed, the tool will have a tendency to torque or twist in your hand when the nut or bolt
seats.
a. Select hex socket that matches the nut or bolt. Then mount the socket onto the square
drive, and fully grip the nut or bolt to be tightened with the hex socket.
b. Hold the tool firmly and apply just enough pressure to keep the socket engaged on the nut
or bolt. Then press the trigger switch to impact the nut or bolt for several seconds.
NOTICE: Always use the correct size impact socket for bolts and nuts. An incorrect size
impact socket will result in inaccurate and inconsistent fastening torque and/or damage to the
bolt or nut.
WARNING
of the bolt or nut will be damaged .
16
Wear protective gloves when removing the socket from the tool, or
first allow the impact socket to cool down. The impact socket may be
Do not over-tighten, as the force of the impact wrench can break the
fastener . Hold the tool vertical with the bolt or nut, otherwise the head
Fig . 8
Impact
Socket
Square
Drive