Skil PWRCORE 20 IW5761B-00 Manual Del Usuario página 14

1 2 3 RM NB
In reverse control mode (RM), the tool loosens a bolt or nut with an impact force you
choose with the speed button first. Once the nut or bolt is completely loose, the tool will stop
automatically to prevent the bolt or nut from falling out.
In nut busting mode (NB) it offers a large, fixed impact force for removing stubborn nuts and
bolts.
NOTICE: Both reverse control mode and nut busting mode are available only when the tool is
set to reverse rotation.
NOTICE: Since the nut busting mode provides a fixed impact force, the speed button will not
be able to adjust the impact force in the nut busting mode.
NOTICE: The work mode can be changed only when any mode-indicator light is shining and
the trigger switch is not depressed. The mode button is disabled when the motor is running.
The work mode will be stored in memory and reactivated the next time the tool is turned on or
when the direction of rotation has been changed. Reset the impact modes as desired.
When the trigger is squeezed slightly, the speed button is pressed, or the mode button is
pressed, any of the five indicator lights will automatically shine green, to indicate the work
mode saved during the last use and will turn off approximately 60 seconds after the variable-
speed trigger switch is released. It means that during approximately one minute after releasing
the trigger switch, the work mode can be changed.
14
Forward
Low-Speed Mode
Medium-Speed Mode
High-Speed Mode
Reverse
Low-Speed Mode
Low-Speed Reverse Control
Mode
Nut Busting Mode
Medium-Speed Mode
Medium-Speed Reverse
Control Mode
Nut Busting Mode
High-Speed Mode
High-Speed Reverse Control
Mode
Nut Busting Mode