Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
3.2 OPERATING PROCEDURCE
IMPORTANT – Do not attempt to break off a pintail without the installation of a collar. This will cause the unsecured
portion of the pintail to eject from the nose at a high speed and force.
When installing lock bolt products:
*
Ensure that the correct nose assembly is fitted.
*
Connect the tool to the air supply.
*
Push the Avdelok® pin through the application hole.
*
Place the collar on the pin (orientate as shown).
*
Keeping the head of the pin against the application, push the
tool on to the protruding pin tail.
*
Fully depress the trigger. One cycle will ensure that the collar is
swaged into the lock grooves of the pin and that the pin breaks
at the breaker groove.
*
Release the trigger. The tool completes its cycle by pushing itself
off the collar and ejecting the pin tail at the rear.
When installing break stem products:-
*
Ensure that the correct nose assembly is fitted.
*
Connect the tool to the air supply.
*
Insert the fastener stem into the nose of the tool.
*
Bring the tool with the fastener to the application so that the protruding fastener enters squarely into the hole of the
application.
*
Fully depress the trigger. The tool cycle will broach the fastener.
*
Release the trigger. The tool completes its cycle.
10
O R I G I N A L I N S T R U C T I O N
Fig.3
Publicidad
Tabla de contenido
