Connecting The Orbmax To The Power Source - Orbitalum ORBmax Traducción Del Manual De Instrucciones Original

enGLISH
Operation ORBMAx
8.5

connecting the ORBmax to the power source

The ORBmax can be connected to an ORBIMAT orbital welding power source with the supplied interface cable (4). This allows the
information whether the residual oxygen value exceeds or underpasses the value preset at the ORBmax to be displayed at the
power source (display only possible at orbital welding power source from Orbitalum Tools). The power source cannot be started
as long as the residual oxygen value lies above the set limit value. If the limit value is exceeded, the process is canceled and a note
is entered in the log.
4
Connection of interface cable ORBIMAT 180 SW
For information on operating the ORBmax in combination with the power source please read the operating instructions of the
respective orbital welding power source from Orbitalum Tools.
40
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
[REV. 20190925] OW_ORBmax_BA_882060201_00__INH-02_EN