Publicidad
Step 9
å
First, fasten the INNER PANEL SKIRT (EE) to the PANEL SUPPORT (AA).
Use three BROWN 1-5/8" FLAT HEAD SCREWS (55S).
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
å
Next, fill the holes in the OUTER PANEL SKIRT (FF) 1/4 to 1/2 full with
GLUE (177M). Then, insert the WOOD DOWELS (15F) into the holes.
Wipe away the excess GLUE.
å
Now, fill the holes in the LOWER PANEL MOLDING (Z) 1/4 to 1/2 full
with GLUE. Then, insert the WOOD DOWELS in the OUTER PANEL
SKIRT (FF) into these holes. Wipe away the excess GLUE.
Z
BROWN 1-5/8" FLAT HEAD SCREW
(3 used in this step)
www.sauder.com/service
FF
e
f a c
s u r
e d
n i s h
U n fi
AA
EE
55S
These surfaces
should be even.
427163
2
177M
Fill the holes 1/4 to 1/2 full with GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely difficult.
Page 15
Publicidad
