Tabla de contenido
Publicidad
Step 24
å
Carefully turn the RIGHT MOLDINGS (X and Y) over.
å
Fasten the RIGHT MOLDINGS (X and Y) to the SMALL TOP (S). Use eight BROWN
1-5/8" FLAT HEAD SCREWS (55S).
å
NOTE: Start each SCREW a few turns before completely tightening any of them.
å
NOTE: Do not overtighten the SCREWS into the TOP.
å
Push four CORD CLIPS (4P) into the holes in the SMALL TOP (S) as shown.
å
NOTE: The CORD CLIPS are used to hold any cords against the TOP.
BROWN 1-5/8" FLAT HEAD SCREW
(8 used in this step)
Page 30
55S
X
Y
Y
X
S
427163
These holes
must be here.
4P
www.sauder.com/service
Publicidad
Tabla de contenido
