Publicidad
Step 3
å
Carefully turn the MODESTY PANEL (M) over.
å
Place the WASHER (82S) into one of the MOLDING
CONNECTOR CLIPS (173M) as shown in the enlarged
diagram. Using your hammer, gently tap on the
WASHER to insert the MOLDING CONNECTOR
CLIP into the hole in the MODESTY PANEL (M).
å
Repeat this method to insert all of the MOLDING
CONNECTOR CLIPS (173M) into the MODESTY PANEL (M).
å
Line up the groove in the MODESTY PANEL MOLDING (N)
over the MOLDING CONNECTOR CLIPS in the MODESTY
PANEL (M) and snap the MOLDING onto the CLIPS.
å
NOTE: The MOLDING should be centered on the
MODESTY PANEL.
www.sauder.com/service
N
M
Use your hammer to tap the WASHER (82S)
into the MOLDING CONNECTOR CLIP (173M).
173M
(5 used)
427163
82S
Be sure the MOLDING
CONNECTOR CLIP is
parallel to the long edge.
173M
M
The groove
is closer to
this edge.
2
Page 9
Publicidad
