Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to avoid
scratching your unit or the floor.
å
Fasten the UPPER PANEL MOLDING (DD) to the LARGE TOP (Q). Use three
BROWN 1-5/8" FLAT HEAD SCREWS (55S).
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
å
Push four CORD CLIPS (4P) into the holes in the LARGE TOP (Q) as shown.
å
NOTE: The CORD CLIPS are used to hold any cords against the TOP.
Surface with more holes
DD
These holes
must be here.
www.sauder.com/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
BROWN 1-5/8" FLAT HEAD SCREW
(3 used in this step)
The holes are
closer to this edge.
Q
427163
55S
4P
0
Page 7
Publicidad
