Publicidad
Step 49
å
To make adjustments to the FILE DRAWER, loosen SCREW #4 in the SLIDES
a 1/4 turn, then turn the cam clockwise or counter-clockwise. Notice how the
drawer raises or lowers as you turn the cam. By adjusting the drawer this way, it
will help the DRAWER FRONT line up better when closed. Tighten the SCREWS
when finished with adjustments.
å
NOTE: Use this same method of adjustment for the DRAWER using SCREW #3.
Loosen screw #4 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #4.
The higher the screw in the oblong hole,
the higher your drawer front will be. The
lower the screw, the lower the drawer front.
www.sauder.com/service
Cam
427163
13
Page 55
Publicidad
