Initial Startup - Kärcher BDS 43/Orbital C Spray Manual De Instrucciones

Detergent tank
1
Cable hooks at the bottom
2
5. Slide the upper cable hook down to
the detergent tank. Make sure the
pin on the tank is seated in the re-
cess on the cable hook.
Illustration I
Detergent tank
1
Pin
2
Star grip
3
Recess
4
6. Tighten the star grip on the upper
cable hook.
7. Attach the hose to the hose nipple
on the device.
Illustration J
Hose nipple
1
Hose
2
8. Guide the chain through the opening
on the handle and hook it in at the
dosing lever for the cleaning agent.
Illustration K
Dosing lever for cleaning agent
1
Chain
2
Connecting the spray system
Only the BDS 43/Orbital C Spray is
equipped with a spray system.
1. Plug the hose from the detergent
tank into the pump inlet.
Illustration L
Hose
1
Pump inlet
2
Pump
3
2. Insert the hose piece at the pump
outlet.
Illustration M
Pump outlet
1
Hose piece
2
3. Plug the other end of the hose into
the spray nozzle distributor.
Illustration N
Hose piece
1
Distributor for spray nozzles
2
10

Initial startup

Attach the pad
1. Select the appropriate pad for the
cleaning task.
2. Make sure the mains plug is discon-
nected.
3. Swivel the cleaning head upwards
by lifting it by the handle.
Illustration O
Handle
1
Cleaning head
2
4. Center and press the pad onto the
pad drive board.
5. Swivel the cleaning bath down-
wards.
Filling with detergent
WARNING
Unsuitable detergents
Health risk, damage to the device
Use only recommended detergents.
The operator carries all increased risks
relating to operational safety and in-
creased risk of accidents if using other
detergents.
Use only detergents free of solvents,
salt and hydrofluoric acid.
Adhere to the safety instructions stated
on the detergent packaging.
ATTENTION
Risk of damage
A cleaning solution with a temperature
above 50 °C can cause damage to the
device.
Do not fill the detergent tank with a
cleaning solution that is above the
maximum temperature of 50 °C.
1. Fill the detergent tank with cleaning
solution.
English