Control Elements; Transport; Initial Start-Up - Kärcher RBS 6000 Serie Manual Del Usuario

1 Mains plug
2 Safety switch (brush)
3 Handle
4 Incline crank
5 Dosing pump
6 Detergent canister
7 Dosing pump switch
8 Emergency-stop button
9 Main switch
10 Water connection
11 Shutoff valves for nozzle pipes

Transport

WARNING
Risk of injury and damage! Observe the
weight of the system when you transport it.
This system can be transported on the bed
of a lorry laying down:
 Remove the spacer rollers.
 Tilt the system onto the brush side with
two people.
 Slide the system onto the lorry bed.
 Secure the system from sliding.
14

Control elements

Initial Start-Up

Install spray guard
1 Splash guard
2 Pin
3 Expanding rivet
4 Angle profile
The two angle profiles are attached to the
frame with expanding rivets for transport,
 remember the installation position of the
angle profiles for the assembly process.
 Hit the pins of the expanding rivets to-
ward the inside with a punch.
 Remove the angle profiles.
 Roll out the included spray guard and
place it on the square pipe.
Note:
The spray guard strips are ondulated on
their short side. During installation, this on-
dulation must face away from the brush.
 Reinstall the angle profile.
 Insert the expanding rivet through the
angle profile, spray guard and the
square pipe and press in firmly.
 Hit the pin of the expanding rivet with
the hammer.
 Repeat this process for all bores in the
angle profiles.
3
-
EN
Install the spacer rollers
 Fasten the two included spacer rollers
on the frame of the system.
Select the height according to the vehi-
cles to be washed.
 Tighten the counter nuts.
Adjust the handle
The handles can be attached in two posi-
tions.
Resetting the height:
 Loosen the screws.
 Swivel the handle down in order to en-
sure that the cable of the safety switch
is not damaged.
 Carefully pull out the handle (cable of the
safety switch is routed in the handle).