Operation; Storage - Kärcher RBS 6000 Serie Manual Del Usuario

Operation

Before each use
 Remove all obstacles and objects in the
way of the washing station.
 Create a water connection.
 Create an electrical connection.
 Check filling level of the detergent con-
tainer and refill if required.
DANGER
Risk of stumbling due to objects on the floor
or supply lines.
 Prior to taking the system into opera-
tion, remove all objects from the wash-
ing station.
 When using a system with a cable drag,
observe the proper routing of the supply
lines.
Behaviour in emergency situations
 In emergencies, release the brush safe-
ty switch.
Preparing the vehicle
 Close windows, doors and roof openings.
 Remove or fold in the side mirror.
 Retract or remove antennas.
 Remove or secure loose parts (tarp
ropes, etc.).
 Close tarps and secure fasten them.
Operations
 Park the vehicle centered at the washing
station or underneath the cable drag.
 Adjust the system to the incline of the
surface to be cleaned by means of the
incline crank.
 Position the system at the start the long
side of the vehicle.
 Open the shutoff valve for a nozzle pipe
located in the direction of the washing
process
 Turn on the main switch.
 Switch on the dosing pump.
 Hold the system with both hands on the
handle in washing direction.
CAUTION
Risk of damage. Do not change the rotation
direction while the brush is running.
 Switch on the brush by pulling on the
safety switch of the brush on the re-
spective handle.
Brush submersion depth
16
Washing direction
 Guide the system along the vehicle at
an even speed by pulling on the handle.
Note:
Always pull - never push the system.
The rotation direction of the brush is select-
ed to cause the least amount of power ef-
fort during pulling.
If the correct contact pressure is used, the
spacer rollers will touch the vehicle lightly.
Too much contact pressure will not improve
the cleaning effect.
If there are stationary, non-foldable mirrors,
the system must be pulled away from the
vehicle slightly.
 Reposition the system at the corners of
the vehicle, readjust the incline if neces-
sary and continue the washing process.
CAUTION
Risk of damage to the supply lines due to
twisting. Change the washing direction
every time you come around the vehicle.
Once all sides of the vehicle have been
washed:
 Switch off the dosing pump.
 Switch the water supply to another noz-
zle pipe.
 Go around the vehicle one more time in
the opposite direction for rinsing.
Finish the washing process
 Pull the washing system away from the
vehicle
 Release the brush safety switch.
 Shut off water supply.
 In case of longer operational breaks:
Turn the main switch to position "0".
Remove the voltage from the supply
line if desired.
5
-
EN

Storage

WARNING
Risk of injury and damage! Observe the
weight of the system when you store it.
 Push the system to the storage area.
 If there is a cable drag on the floor, you
might need to disconnect the supply
lines.
 If outdoors or in an open hall, store the
system protected from wind or secure it
from tipping over by means of ropes or
chains.
 Activate the parking brakes on the roll-
ers.
DANGER
Risk of injury due to system toppling over.
Store the system protected from wind and
protect it from tipping over.
Frost protection
Protect the water-carrying parts of the plant
against frost because they can get totally
damaged.
If there is a chance of frost, the system
must be drained completely:
 Shut off water supply.
 Blow the supply line (water hose) and
the system out with compressed air.
 Switch on the brush drive so that the
water is ejected from the brush.