Handling And Transportation; Maintenance Table; Problem Identification; Attachments On Request - ST CP1 430 Manual De Instrucciones

8. STORAGE
When the machine is to be stored away:
1. clean the machine thoroughly (par. 7.4);
2. check the integrity of the machine;
3. store the machine:
• in a dry place;
• protected from inclement weather;
• in a place out of children's reach;
• making sure that keys or tools used for maintenance
are removed.
9.

HANDLING AND TRANSPORTATION

Whenever the machine is to be handled, raised, transport-
ed or tilted you must:
• Stop the machine (par.6.5) until the moving parts come to
a complete halt.
• Wear heavy work gloves.

10. MAINTENANCE TABLE

MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear discharge
guard; Check the grass catcher; Check the cutting means.
General cleaning and inspection; Checking for any damage to the machine.
If necessary, contact the authorised service centre.
Replacing the cutting means.
POWER SUPPLY
Check the integrity of the power cable and good condition of the sockets.
*** The operation must be carried out by your Dealer or a Authorised Service Centre

11. PROBLEM IDENTIFICATION

If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The electric lawn
mower does not
work.
2. The electric lawn
mower turns off the
current.
3. The cut grass is no
longer collected in
the grass catcher.
4. Mowing is difficult.
5. Unusual machine
vibrations.

12. ATTACHMENTS ON REQUEST

12.1 MULCHING KIT (Fig.20)
Finely chops the cut grass and leaves it on the lawn.
Intervention
PROBABLE CAUSE
There is no current on the
machine.
The amperage of the socket is
not sufficient.
There are other electrical
devices in operation.
The cutting means received a
stroke.
The inner part of the chassis is
soiled.
The cutting means is not in good
condition.
Damaged or loose parts.
• Hold the machine in the points offering a safe grip, taking
into account the weight and its division.
• Use an appropriate number of people for the weight of
the machine and the characteristics of the vehicle or the
place where it must be placed or collected.
• Make sure that machine movements do not cause dam-
age or injuries.
When transporting the machine on a vehicle or trailer, always:
• Use an access ramp of suitable strength, width and
length.
• Load the machine with the motor switched off and pushed
by an adequate number of people.
• Lower the cutting means assembly.
• Position it so that it cannot cause a hazard for anybody.
• Fasten firmly to the means of transport using ropes or
chains to prevent it from tipping over.
Frequency
Before use
After each use
Before use
Check the electrical connection.
Connect the machine to a power socket with sufficient
amperage.
Do not connect other devices at the same time to the same
power socket.
Sharpen the cutting means or replace it.
Check the fins that direct the grass to the grass catcher.
Clean the inner part of the chassis to facilitate the evacuation of
the grass toward the grass catcher.
Sharpen the cutting means or replace it.
Stop the machine and remove the supply cable.
inspect for possible damage.
Check for and tighten any loose parts.
Have all checks, repair work and replacements carried out by a
Authorised Service Centre only.
EN - 6
Notes
par. 6.2
par. 7.4
- par. 7.3.1 ***
par. 6.1.1
SOLUTION